Wilwood Rotors

Discussions related to Solo
Post Reply
jcox07
Posts: 7044
Joined: Tue Feb 08, 2011 6:40 am

Wilwood Rotors

Post by jcox07 »

Any one ever used a Wilwood Rotor and if so what are your thoughts on them?
JY ( Jeff ) Cox
ETR R.E
2018-2021, 2022, 2023 Solo Nationals Co Chairman
2010 GT500
thrdeye
Posts: 14089
Joined: Fri Dec 05, 2003 12:31 pm
Location: Lenoir City

Re: Wilwood Rotors

Post by thrdeye »

dba is good if it's available in your size. had them on the skunk with my stock brakes.
Chris Harp
2009 Mazda RX-8 | 2018 Toyota Tundra | 2011 BMW M3
thrdeye
Posts: 14089
Joined: Fri Dec 05, 2003 12:31 pm
Location: Lenoir City

Re: Wilwood Rotors

Post by thrdeye »

But also.....it's a rotor.

I assume you're trying to cut weight?
Chris Harp
2009 Mazda RX-8 | 2018 Toyota Tundra | 2011 BMW M3
jcox07
Posts: 7044
Joined: Tue Feb 08, 2011 6:40 am

Re: Wilwood Rotors

Post by jcox07 »

yep trying to cut weight and they have one that will cut about 10-12 pounds depending on which hat I have to go with... I have dba on it now at 25.6 pounds each
JY ( Jeff ) Cox
ETR R.E
2018-2021, 2022, 2023 Solo Nationals Co Chairman
2010 GT500
thrdeye
Posts: 14089
Joined: Fri Dec 05, 2003 12:31 pm
Location: Lenoir City

Re: Wilwood Rotors

Post by thrdeye »

Lots of race teams use them....lots.

sent from typotalk
Chris Harp
2009 Mazda RX-8 | 2018 Toyota Tundra | 2011 BMW M3
TedV
Posts: 6219
Joined: Wed Dec 17, 2003 5:55 pm

Re: Wilwood Rotors

Post by TedV »

Worst case, carry your dba's and if the will wood takes a poo, swap the ones you know work back on.
Ted V.
don't make me list all my VW's
User avatar
01badz28
Posts: 4064
Joined: Fri Dec 19, 2003 10:13 am
Location: Knoxville, TN

Re: Wilwood Rotors

Post by 01badz28 »

I think Kelly Munsey had Wilwoods on his Impala (either that or it was Terry - I know one them ran Wilwoods). If they could stop those boats time and time again, you will have no problems.
Ryan E. Jarrard
2001 Camaro Z28, SM #24
2011 BMW M3 Coupe
1989 BMW M3
User avatar
Tim Gillespie
Posts: 48
Joined: Thu Sep 12, 2013 1:23 pm
Location: Lancing, TN

Re: Wilwood Rotors

Post by Tim Gillespie »

I have Wilwoods front and rear on the Cobra. Jim does also, at least on the front. They are two-part, and the hat bolts should be safety-wired. I have the 6-pot calipers in the front and 4-pot in the rear. They're light and work great. Are you going to use Wilwood calipers too? If so, the BP-10 compound pads tend to be the best for autocross.

Tim
My Factory Five Cobra build site: http://www.timsroadster.com
oldmuscle69
Posts: 2243
Joined: Sun Oct 10, 2010 7:08 am
Location: on the wheeloldmuscle69@yahoo.com

Re: Wilwood Rotors

Post by oldmuscle69 »

Terry's boat stopped very well.....
Bob Colbert
Apexemall
Posts: 24
Joined: Thu May 05, 2011 7:31 pm

Re: Wilwood Rotors

Post by Apexemall »

I have Wilwood big brakes on my WRX front and back - including 2 piece rotors. No problems in 1 1/2 years. I'll be over Sunday, so you can check them out.

I do not like the Wilwood pads. Feel "lumpy" when hot. Probably off gasing. I'm using Carbotech AX6 pads and stopping is excellent. Mark P drove it in Atlanta, so he can give you an opinion.

Clyde Stahl
Clyde Stahl
54 C1
69 C10
11 C6
04 WRX
User avatar
Tim Gillespie
Posts: 48
Joined: Thu Sep 12, 2013 1:23 pm
Location: Lancing, TN

Re: Wilwood Rotors

Post by Tim Gillespie »

Apexemall wrote:I do not like the Wilwood pads.
Wilwood offers about a dozen different pad compounds.

http://www.wilwood.com/BrakePads/BrakePadsApp.aspx

Most retrofit kits come with BP-10 compound, but if you don't mind taking the time to swap pads before an event, the polymatrix A compound is excellent for autocross.

Tim
My Factory Five Cobra build site: http://www.timsroadster.com
jcox07
Posts: 7044
Joined: Tue Feb 08, 2011 6:40 am

Re: Wilwood Rotors

Post by jcox07 »

Any pad other than carbotech on my car is a waste of time. I have run hawk and the stock pads and none of those have come close to stopping the shelby as good as the carbotech do.
JY ( Jeff ) Cox
ETR R.E
2018-2021, 2022, 2023 Solo Nationals Co Chairman
2010 GT500
Post Reply